Fasteners for conveyor belts
Conventional or stainless steel fasteners are designed for mechanical connection of the belts.
Connecting of belts by using fasteners not always prove to be satisfactory though, thus company production division glues conveyor belts on rubber by using special adhesives according to producer’s technologies or by connecting with press EL-20-NE and using heat.
PVC and PU belts are connected with press MVP-1320 and using heat.
Fasteners RS62, RS125, RS187:
- Rigid and impact resistant
- Friction resistant
- Easy to mount
Fasteners of group G
- Used for very small shaft diameters
- Low noise emission
- Abrasion resistance
- Employed connections are 20 % thinner than the employed material
R2 and R5 fasteners
- Easy and quickly mounted
- Rivet ensure long service life without damaging the belt
- Suitable for different type of rubberised belts
Fasteners RS62 are used when belt thickness ranges from 1.5 to 3.2 mm, and shaft diameter accounts for no less than 50 mm. These connections RS62 withstand force up to 17 kN/m. Connections can be of steel, stainless steel of type 316, and magnetic stainless steel of type 430.
Fasteners RS125 are used when belt thickness ranges from 3.2 to 4.8 mm, and shaft diameter accounts for no less than 75 mm. These connections RS125 withstand force up to 28 kN/m. Fasteners can be of steel, stainless steel of type 316, magnetic stainless steel of type 430, and with higher friction resistance.
Fasteners RS187 are used, when belt thickness ranges from 4.8 to 6.4 mm, and shaft diameter accounts for no less than 100 mm. These connections RS128 withstand force up to 35 kN/m. Fasteners can be of steel, stainless steel of type 316, and with higher friction resistance.
Fasteners of group G – it is connections of wire group that are used for connecting of light, short, and thin conveyor belts.
